Active Ingredient: Clomiphene
As the segments bend relative to each other from variation in wave height along the length of the train, this motion can be used to turn a generator, through a mechanical linkage or by pumping a fluid through turbine.
Pelamis is developing one of the best known examples of an attenuator device, and installed just over 2 MW of capacity in the Agucadoura wave farm in.
Terminators are wave energy devices that extend across the wave front, perpendicular to the direction of wave travel like the direction a surfer travels in a pipeline.
Some terminators, like OceanLinx device, funnel the incoming wave energy into an oscillating water column which pushes air through a special turbine that spins in the same direction regardless of the direction of air flow.
Other terminator devices use a different strategy call overtopping, where the waves slosh water up ramps into a reservoir. The sea water drains out of the reservoir through a turbine which drives a generator.
Wavedragon deployed a prototype of such an overtopping device in off the coast of Denmark and is currently preparing to deploy a full scale prototype with a 7 MW capacity.
Like oscillating wave surge convertors, devices with paddle-like arms that wave back and forth around a pivoting joint as the waves pass over them. Some systems use hydraulic conversion methods, pumping sea water through a turbine using hydraulic rams or hose pumps.
Hydraulic rams feature a piston in a cylinder with an inlet valve and an outlet valve.
As the piston withdraws from the cylinder the inlet valve opens and low pressure sea water is drawn into the device. As the piston reverses direction and compresses, the inlet valve closes and the pressure in the cylinder increases.
When the pressure exceeds a threshold the outlet valve is forced open and high pressure sea water is pumped out of the cylinder to a water turbine. Hose pumps deliver high pressure water by mimicking the human digestive tract.
Rollers propagate a constriction along the length of a flexible hose, which create high pressure ahead of the pinch point and low pressure behind it.
In both cases the high pressure sea water is pumped through a turbine to drive a generator.
If the turbine is located with the device, then electric power is transmitted to shore through sub-sea electric cables. Alternatively, the wave energy device can pump high pressure sea water to the shore instead, where it will drive an on-shore turbine and generator.
You will need to have a pelvic examination before each treatment cycle. You must remain under the care of a doctor while you are using Clomid.
You will most likely ovulate within 5 to 10 days after you take Clomid. To improve your chance of becoming pregnant, you should have sexual intercourse while you are ovulating.
This will help you determine when you can expect ovulation to occur. In most cases, Clomid should not be used for more than 3 treatment cycles.
Store at room temperature away from moisture, heat, and light. See also: Clomid dosage information in more detail What happens if I miss a dose?
Call your doctor for instructions if you miss a dose of Clomid.The aim of this study was. Twenty-five milligrams of clomiphene citrate presents positive effect on treatment of male of 25 mg clomiphene citrate CC testosterone production pathway and to address the applicability of this medication as a therapeutic option for symptomatic hypogonadism.